Step 6: Install Software Nec Express5800/Ft Series Offers - NEC Express5800/320Fd-LR User Manual

Step 6: Install Software NEC Express5800/ft Series offers

Install the software provided by NEC Express5800/ft series by the following procedures.
Before installing software
Before installing the software enclosed with NEC Express5800/ft Series, apply the errata kernel
(2.6.18-92.1.10) of Red Hat Enterprise Linux Advanced Platform 5.2. You can download the
following kernel package from Red Hat Network (https://rhn.redhat.com/).
Red Hat Enterprise Linux (v. 5 server) x86_64:
kernel-2.6.18-92.1.10.el5.x86_64.rpm
kernel-devel-2.6.18-92.1.10.el5.x86_64.rpm
(Check) Write down the message digest on the right side of the package name before the download.
Apply the errata kernel in the following procedure.
1. Save the package downloaded from Red Hat Network in an arbitrary directory, and go to the
directory.
2. Confirm if you could download each package correctly. If the message digest on the right side of
the package name matches the result of the following command, you successfully downloaded the
correct one.
# md5sum kernel-2.6.18-92.1.10.el5.x86_64.rpm
# md5sum kernel-devel-2.6.18-92.1.10.el5.x86_64.rpm
3. Run the following command to apply the kernel package.
# rpm -ivh kernel-2.6.18-92.1.10.el5.x86_64.rpm
# rpm -ivh kernel-devel-2.6.18-92.1.10.el5.x86_64.rpm
4. Reboot the system.
# reboot
After you apply the kernel package, install the software enclosed with NEC Express5800/ft Series.
ft Server Control Software
IMPORTANT:
The installation of ft Server Control Software must be executed by root user.
Java package is required for ft Server Control Software installation. Install the java
package with the below procedure.
Set the Red Hat Linux Enterprise Linux Advanced Platform 5.2 Supplementary CD (1 of 2) on
1.
the optical disk drive of the device.
Enter the command described below and mount the CD-ROM.
2.
The mount point is described as /mnt here.
# mount /dev/hda/mnt
Linux Setup 4-19