NEC Express5800/320Fd-LR User Manual page 95

md0 /boot
md1 swap
md2 /
md3 /var/crash
md4
md5
md6
md7
<<< When you create striping array using RAID 1 devices md4 and md6,
confirm the each device is operating properly (Status must be
"DUPLEX"), and is not mounted as system file (There is no description
in Partition). >>>
Execute Make Striping Array (RAID1+0) of ftdiskadm and install the target RAID 1
2.
device into striping array.
# ftdiskadm
Command action
1 List RAID Arrays
2 List Internal Disks
3 Make Mirroring Arrays
4 Repair Mirroring Arrays (RAID1)
5 Delete Mirroring Arrays (RAID1)
6 Remove Disk Partitions (RAID1)
7 Make Striping Array
8 Delete Striping Array
c Configurations
q Quit
Command: 7
[Make Striping Array
* Which raid1 device numbers? ['?' for help] => 4,6
<<< In the entering screen above, separate the RAID 1 device numbers
by "," and define the RAID 1 device you would like to install (Do
not include blank in the value). When you create striping array using
md4 and md6, enter "4,6" like above and then press ENTER. >>>
( - ) DUPLEX
( - ) DUPLEX
( - ) DUPLEX
( - ) DUPLEX
( - ) DUPLEX
( - ) DUPLEX
( - ) DUPLEX
( - ) DUPLEX
(RAID1)
(RAID1+0)
(RAID1+0)
(RAID1+0)]
Linux Setup 4-35
(1)sda1 (4)sdd1
(1)sda2 (4)sdd2
(1)sda3 (4)sdd3
(1)sda5 (4)sdd5
(2)sdb1 (5)sde1
(2)sdb2 (5)sde2
(3)sdc1 (6)sdf1
(3)sdc2 (6)sdf2