Fujitsu ETERNUS DX80 S2 User Manual page 166

Appendix B Audit Log List
Event code
02060015
02060016
02060017
02060018
02060019
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Operation-
Upper: Message
Lower: Detailed information
Set Host Response
$a $b $c
[Name= No= Status= Inquiry=
Conflict= $f Timeout= $g Version=
$j $k
Symmetric= LUN_Change=
Unique_Sense= $m iSCSI_Response=
$o
Sense_Preset= [Sense_From=
$s $t $u
Sense_To= / / ] Tpgs_Mode=
$w
Tpg_Referrals= iSCSI_Rsv_Range=
Delete Host Response
[Name= $a ]
Set CA Reset Group
$a
[Port= ]
Create Port Group
$a $b $c
[Name= No= Port= ]
Set Port Group
$a $b
[Name= New_Name= Port=
Copyright 2013 FUJITSU LIMITED
The host response parameters are set or changed.
$a : Host response name
$d $e
Vpd=
$b
: Host response number
$h Mode= $i
$c
: Load Balance Response (Busy, Queue-Full,
$l
LUN_Expand=
Unit-Attention)
$n
$d
: Byte-0 of Inquiry Response (Disable, 7F,
$p $q/$r
/
20)
$v
$e
: Inquiry VPD ID Type (Type1, Type1-3,
$x
]
Type3)
$f
: Reservation Conflict Response (Enable,
Disable)
$g
: Command Timeout Interval [sec] (10 –
255)
$h
: Standard Data Version (3, 4, 5)
$i
: Host Specific Mode (Normal, AIX, HP-UX,
Linux, BS2000)
$j
: Symmetrical Access (Active, Passive)
$k : Report of volume mapping modification
(Enable, Disable)
$l
: Report of expansion volume capacity modi-
fication (Enable, Disable)
$m
: Vendor Unique Sense Code (Enable,
Disable)
$n
: iSCSI Discovery Reply Mode (Port, All)
$o : Sense Data Conversion (None, Linux,
Windows, Custom)
$p
: Sense Key for sense information before
conversion (0 – F or *)
$q
: Sense Code for sense information before
conversion (00 – FF or *)
$r
: Additional Sense Code for sense
information before conversion (00 – FF or *)
$s
: Sense Key for sense information after
conversion (0 – F or *)
$t
: Sense Code for sense information after
conversion (00 – FF or *)
$u
: Additional Sense Code for sense
information after conversion (00 – FF or *)
$v : TPGS Mode (Enable, Disable)
$w
: TPG Referrals (Enable, Disable)
$x : iSCSI Reservation Range (Port, System)
The host response is deleted.
$a
: Host response name
The CA Reset Group parameter is set or deleted.
$a
: Port number (example: 001, 002)
The port group is created.
$a
: Port group name
$b
: Port group number
$c
: Port number (example: 001, 002)
The port group settings are changed.
$a : Port group name
$c
]
$b
: New port group name
$c
: Port number (example: 001, 002)
166
Description
P3AM-4842-12ENZ0