Fujitsu ETERNUS DX80 S2 User Manual page 176

Appendix B Audit Log List
Event code
020C0009
020C000A
020C000B
020C000E
020C000F
020C0010
020C0011
020C0012
020C0013
020C0014
020C0015
020C0016
020C0017
020C0018
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Operation-
Upper: Message
Lower: Detailed information
Set Disk Patrol
$a $b
[Disk_Type= Write_Check=
Check_Code_Check= $c Disk_Port_Check=
$e $f
Interval= Operation_Size=
Free_Area_Check= $g ]
Release Reservation
$a
[Volume_No= ]
Set Disk Performance Monitor
$a
[Monitoring= Disk_Isolation=
Threshold= $d Interval= $e Event_Notification=
Set Debug Mode
$a $b
[Trace_Level= Panic= ]
Start Performance
[Interval= $a ]
Stop Performance
Detail information is not displayed.
Set Bind In Cache
[Size= $a ]
Delete Event
Detail information is not displayed.
Initialize System Disk
Detail information is not displayed.
Change Master
Detail information is not displayed.
Write Back Pinned Data
$a
[No= ]
Clear Pinned Data
$a
[No= ]
Forced Write Back
Detail information is not displayed.
Forced Restore
Detail information is not displayed.
Copyright 2013 FUJITSU LIMITED
The disk patrol parameters are set.
$a : Target disk type (None, Data, Spare,
Unused)
$d
$b
: Write Check (Enable, Disable)
$c
: Check Code Check (Enable, Disable)
$d
: Disk Port Check (Enable, Disable)
$e
: Interval between each test increment [sec]
(1, 2, 3, 4, 5, 6, 7, 8, 9, 10)
$f : Operation Size [MB] (0.5, 1.0, 2.0, 4.0, 8.0,
16.0)
$g : Verify Check for Unused Area of Data Disk
(Enable, Disable)
The reservation status of the volume is released.
$a
: Volume number
The disk performance monitoring parameters are
changed.
$b $c
Factor=
$a
: Monitoring function (Enable, Disable)
$f ]
$b
: Disk isolation (Enable, Disable)
$c
: Error monitoring factor [%] (0.1 – 10.0)
$d
: Threshold of allowable error (7.2 – 720.0)
$e : Monitoring time [hour]
$f
: Event notification (Enable, Disable)
The debug mode is set.
$a : Trace level (example: 00-FF)
$b
: Collection mode of the panic dump (Nose
and Tail, Fortnight, Disable)
Performance information collection is started.
$a
: Collection interval [sec] (30, 60, 90, 120,
150, 180, 210, 240, 270, 300)
Performance information collection is stopped.
The Bind-in-Cache memory size is changed.
$a
: New capacity (example: 256MB)
All of the event logs are deleted.
The BUD is initialized.
The master CM is changed.
The pinned data is written back to the volume.
$a
: Volume number
The pinned data in the cache memory is deleted.
$a : Volume number
Write back is forcibly performed.
Restoration is forcibly performed.
176
Description
P3AM-4842-12ENZ0