Fujitsu ETERNUS DX80 S2 User Manual page 71
Disk storage system
Hide thumbs
Also See for ETERNUS DX80 S2:
- Cli user's manual (756 pages) ,
- User's manual & installation instructions (147 pages) ,
- User manual (144 pages)
Table of Contents
Advertisement
Chapter 5 Maintaining Optional Products
5.1 Installing Drives
4-3
Swing the lock lever in the direction of the arrow, until the lock clicks shut.
4-4
Check that the newly installed drive's DRIVE READY LED lights up green.
5
Repeat
6
If a wrist strap is used, remove the wrist strap.
7
In the [Disks] screen of [Component] on the ETERNUS Web GUI screen, check that the added
drives are recognized.
8
Set up RAID groups, volumes, hot spares, and Host Affinity settings on the new drives, as
required.
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Operation-
Step 3
and
Step 4
for each additional drive.
Copyright 2013 FUJITSU LIMITED
Lock lever
71
End of procedure
P3AM-4842-12ENZ0
Advertisement
Table of Contents
