JVC VN-H37U Instructions Manual page 62

Internet Explorer Setting
Settings (continued)
Protocol Page (continued)
B
Protocol Settings (continued)
HTTP Server Port
HTTPS Server Port
SNMP
AMX Device Discovery
Protocol
62
You can change the port number for the built-in HTTP server of
the camera.
[Set values: 1 to 80 to 65535]
Memo:
● To access the camera from Internet Explorer, enter the
following in the Internet Explorer address bar when the camera
is set to its default settings.
http://192.168.0.2
If the port number has been changed to 8080, enter it after the
IP address as follows.
http://192.168.0.2:8080
Enter [:] and the port number
● If you change the HTTP server port, the port for the video
stream deliver request also changes.
You can change the port number for the built-in HTTPS server of
the camera.
[Set values: 1 to 443 to 65535]
Memo:
● To access the camera from Internet Explorer, enter the
following in the Internet Explorer address bar when the camera
is set to its default settings.
https://192.168.0.2
If the port number has been changed to 8080, enter it after the
IP address as follows.
https://192.168.0.2:8080
Enter [:] and the port number
● If you change the HTTPS server port, the port for the video
stream deliver request also changes.
Sets SNMP.
[Set values: ON, OFF]
You can change the AMX device discovery protocol. Set this to
"ON" when using the camera with an AMX system.
[Set values: ON, OFF]
* The [Set values] in bold letters are factory defaults.