Sharp IV-S30 User Manual page 87

Continued from the previous page
Return to the [TYPE MEAS COND] menu.
æ When "MEASUREMENT 0" is selected.
[TYPE MEAS COND]
1OBJECT TYPE NO.
2SELECT CAMERA
3IMG PRE-PROCESS
4MEASURE 0 CAM1
[MEAS 0 CAM1 COND]
1MEAS SELECTION
2COMPARE IMGS
3CHNG GRAY LEBEL
4SPACE FILTER
OPS-MENU RETURN LOCK
æ When "MEASUREMENT 1 to 4" is selected.
[TYPE MEAS COND]
1OBJECT TYPE NO.
2SELECT CAMERA
6MEASUREMENT 1
[MEASUREMENT1]
1MEAS SELECTION
2SELECT CAMERA
3CHNG GRAY LEBEL
4SPACE FILTER
OPS-MENU RETURN LOCK
With this settings concerning comparative calculations between images are complete.
00(0~63) NO YES
CAM1&2 CAM1&NG-IMG
(TO NEXT SUB-MENU)
NO (MEAS-COND) NO
NO POSI-DEVIATION
NO COMPARE-IMGS(CAM1)
NO YES(00.0TIMES γ+ γ - CHNG-L INCRS-M)
NO NUM-OF-TIMES 0(0~5)
00(0~63) NO YES
CAM1&2 CAM1&NG-IMG
CHK-DEG-MATCH C1 (MEAS-COND)
NO POSI-DEVIATION CHK-DEG-MATCH
INSPECT-LEAD INSPECT-BGA/CSP
MEAS-BIN-AREA CNT-BIN-OBJ LABEL-BIN-OBJ
POINT-MEAS MULTI-POSI MULTI-MATCHES
CAM1 CAM 2 CAMPARE-IMGS(CAM1)
NO YES(00.0TIMES γ+ γ - CHNG-L INCRS-M)
NO NUM-OF-TIMES 0(0~5)
* The display COMPARE-IMGS(----)" will be displayed when 3
COMPARE IMGS" on the [IMG PRE-PROCESS] menu is set to
NO." - See the previous page.
3-25
Setting the Conditions for Each Object Type
When "OBJECT TYPE NO."
is set to 00.
When "CAM1" is selected.
1. Select "COMPARE-IMGS"
and press the SET key.
When "COMPARE-IMGS"
(previous page) is set to
"CAM1." *
When "OBJECT TYPE NO."
is set to 00.
When "CHK-DEG-MATCH" is selected.
When " MEASUREMENT1" is selected.
1. Select "COMPARE-IMGS"
and press the SET key.
When "COMPARE-IMGS"
(previous page) is set to
"CAM1." *
3