Pe Sensor Unit Removal - Epson Stylus PHOTO 890 Service Manual

EPSON Stylus Photo 890/1280/1290

4.2.15 PE Sensor Unit Removal

1. Remove HOUSING. (Refer to Section 4.2.1)
2. Remove the ASF Unit. (Refer to Section 4.2.10.)
3. Remove the DE Unit. (Refer to Section 4.2.9.)
4. Remove PAPER GUIDE, RIGHT Unit. (Refer to Section 4.2.13.)
5. Remove the timing belt. (Refer to Section 4.2.11.)
6. Release 2 hooks securing the PE sensor unit to FRAME, TOP, lift up the PE
sensor unit, and then remove it to the rear.
Hooks
PE Sensor Unit
Figure 4-66. PE Sensor Unit Removal
C H E C K
When installing the PE Sensor Unit, ensure that the sensor lever
P O I N T
is set in the square hole in PAPER GUIDE, RIGHT Unit. (See
Figure 4-59.)
DISASSEMBLY AND ASSEMBLY Disassembly Procedures
Revision C
117