Refurbishment For Doa - Epson Stylus PHOTO 890 Service Manual

EPSON Stylus Photo 890/1280/1290
5. The following message appears. After replacing both black and color I/Cs with
new ones, click Yes. The printer begins the ink charge operation.
Yes
Figure 5-40. I/C Replacement Message
6. When the ink charge is completed, the following message appears on the window.
Figure 5-41. Ink Charge Replacement Completed
7. To exit or continue the program, click Quit on the lower left. Refer to Figure
5-17."Exit Window" on page -131.
ADJUSTMENT
No
Individual Adjustment Program

5.3.6 Refurbishment for DOA

This function is used when the cavity of the printhead and cap assembly needs to be
cleaned.
n
After carrying out this function, replace the Waste Drain Ink
C A U T I O N
Pad with a new one and reset the Waste Drain Ink Pad Counter
(Protection Counter). If not, ink or S46 liquid may leak from the
ink pad during the transportation.
n
Prepare the following tools:
1. Dummy Ink Cartridges
2. Injector
3. S46 Liquid
n
This operation is available only once. Do not use this function
repeatedly. Repetition of this function may cause overflow of the
ink and S46 liquid.
n
When you refurbish a repairing product using the program, do it
on your responsibility.
n
When you charge S46 liquid into dummy ink cartridges with the
injector, make sure to full the cartridges up with the S46 liquid.
If not, the printhead may not be completely cleaned in this
operation.
n
Keep the S46 liquid and dummy ink cartridges clean even not in
use.
1. Set the dummy cartridges I/Cs filled with S46 to the CR unit.
2. Start the program and input all the required information on the initial window.
Then the main menu appears on the screen. (See 5.2.4.1"Adjusting Program Initial
Setting" on page -128)
3. Select Maintenance Items.
Revision C
141