Sharp IV-S30J User Manual page 161

Multiple Positional Measurement
2) Move the cursor to the "EVALUATION COND"
item on the Menu tree screen and press the
SET key.
The "EVALUAT COND"(evaluation conditions) screen will appear.
For details about the evaluation conditions, see page 3-17.
- When "GRAY-SRC" is selected on line "
MODE."
- When "EDGE DTECT" is selected on line "
MODE."
Numeric calculation setting
- Press the TRG/BRT key to move the cursor to the upper function menu, and highlight "COND" using
the left and right arrow keys. Press the SET key to show the popup menu. Select "NUM-CALC" from
the popup menu.
- Select "NUM-CALC" on the menu tree.
See "Chapter 14: Numerical calculations."
Output condition setting
- Press the TRG/BRT key to move the cursor to the upper function menu, and highlight "COND" using
the left and right arrow keys. Press the SET key to display the popup menu. Select "OUT" from the
popup menu.
- Select "OUT-COND" on the menu tree.
See "Chapter 16: Setting the Input/Output Conditions.
SELECT OBJECT TYPE COND
OBJECT TYPE COND
TYPE00
TYPE RUN COND
IMAGE-ADJ
MEA-CND(CAMERA1)
MEASO
POSI-CORRECT
MEAS01(MULTI-POSI)
IMG PRE-PROC
MEAS CND
EVALUATION COND
DISTANCE&ANGLE COND
NUM-CALC
OUT-COND
MEAS(NEW)
MEA-CND(CAMERA2)
FINAL NUM. CALC
FINAL OUTPUT COND
OBJ-TYPE I/O
OBJ TYPE SYS.
SET=TO NEXT SUB-MENU ESC=BACK SEL=CHNG IMG TRG=POPUP
EVALUAT COND SCREEN COND SAVE EDIT SEL
1REGISTER NO.
2CONDITION SET
3NUMBER OF OBJ
4DTECT NUMBER
5MATCH LVL
X COORD.
Y COORD.
6TEST
EVALUAT COND SCREEN COND SAVE EDIT SEL
1REGISTER NO.
2CONDITION SET
3NUMBER OF OBJ
4DTECT NUMBER
X COORD.
Y COORD.
5TEST
11-10
F C1 DRK
1REGISTER NO.
2CONDITION SET
3NUMBER OF OBJ
4DTECT NUMBER
5MATCH LVL
6TEST
REG-COND(S)
REG-COND(E)
F C1 BRT
0(0~3) [TEST RESULT] [OUTPUT]
AUTO(–10%)
000~128 K= NO
000~(0~000)
-10000~+1000 M0= NO
X0=
Y0=
EXEC(WITH-POSI.ADJ WITHOUT-POSI.ADJ)
F C1 BRT
0(0~3) [TEST RESULT] [OUTPUT]
AUTO(–10%)
000~128 K= NO
000~(0~000)
X0=
Y0=
EXEC(WITH-POSI.ADJ WITHOUT-POSI.ADJ)