Chapter 3 : Setting Measurement Conditions; Outline - Sharp IV-S30J User Manual

Chapter 3 : Setting Measurement Conditions

3-1 Outline

The measuring conditions for each object type are set on the "OBJECT TYPE COND"
(conditions for object type) menu. A maximum of 16 object type numbers can be
registered.
How to enter the setting screen
On the MAIN MENU, move the cursor to "OBJECT TYPE COND" and
press the SET key. The "SELECT OBJECT TYPE COND" screen will
appear. Select "TYPE00," "MEA-CND(CAMERA1)," and "MEAS0" or
"MEAS(NEW)."
Note: "MEAS0" is only used for measuring positional deviation.
Choose a measurement program from the popup menu at
" MEAS SELECTION" to bring up the "MEAS CND" screen.
For details, see Chapter 8: "Setting Example Using the
Menu Tree" in the Instruction and Hardware.
Note: New measurement programs are allocated to "MEAS01"
through "MEAS04." The smallest measurement number
available (from 1 to 4) will be assigned. "MEAS0" is
dedicated to positional deviation measurements.
Setting the Conditions for Each Object Type
MEASUREMENT 1
1MEAS SELECTION
3-1
SELECT OBJECT TYPE COND
OBJECT TYPE COND
TYPE00
TYPE01
TYPE02
TYPE03
TYPE04
TYPE05
TYPE(NEW)
SELECT OBJECT TYPE COND
OBJECT TYPE COND
TYPE00
TYPE RUN COND
IMAGE-ADJ
MEA-CND(CAMERA1)
MEAS0
POSI-CORRECT
MEAS (NEW)
MEA-CND(CAMERA2)
FINAL NUM.CALC
FINAL OUTPUT COND
OBJ-TYPE I/O
OBJ-TYPE SYS.
TYPE(NEW)
SCREEN COND SAVE
POSI-DEVIATION
NO
POSI-DEVIATION
CHK-DEG-MATCH
INSPECT-LEAD
MEAS-BIN-OBJ
LABEL-BIN-OBJ
POINT-MEAS
MULTI-POSI
MULTI MATCHES
3