Halt On Ng Measurement - Sharp IV-S30J User Manual

Setting Measurement Conditions

[4] Halt on NG measurement

You can stop all measurements when an NG image
(according to the final evaluation results) occurs while
operating the IV-S30J.
Select " HALT ON NG MEAS" on the "OBJECT
TYPE SYS." menu.
3
1 HALT ON NG MEAS 1 1 1 1
NO
YES
NO (NG MEAS DISP)
Shown below is an example of an NG image that occurred during measurement 1.
NG occurred
Even if an NG image (final evaluation result) is detected while
operating the IV-S30J, the system will continue making
measurements.
When an NG image is detected (according to the final
evaluation result) while operating the IV-S30J, the controller
will stop making measurements.
Even if an NG image (final evaluation result) is detected while
operating the IV-S30J, the system will continue making
measurements. But, it displays the occurred NG
measurements at first.
(Setting whether to stop measurements when an NG occurs)
Wait for trigger input
Processing measurement 0, camera 1
Processing measurement 0, camera 2
Processing measurement 1
Processing measurement 2
Processing measurement 3
Processing measurement 4
OBJ-TYPE SYS. SCREEN SAVE
1HALT ON NG MEAS
YES
2MNTR LIGHT LVL(CAM1) YES
3LIGHT LV COND
(TO NEXT SUB-BENU)
4MNTR LIGHT LVL(CAM2) YES
5LIGHT LV COND
(TO NEXT SUB-MENU)
6MOVE ALL WINDOW
(TO NEXT SUB-MENU)
Description
"No" "Yes"
- Stops processes
of measurements 2
to 4
3-38
F C1 BRT
NO
YES
NO(NG MEAS DISP)