Call Forward; Call Forward Types; Call Forward Settings - Toshiba IP5000 Series User Manual

Enable Background
Music on your
Telephone Speaker
Cancel Background
Music on your
Telephone Speaker
Adjust Volume

Call Forward

Call Forward
Types
System Call Forward
Station Call Forward
IPedge UG 01/13
Press BGM. LED turns on. Or,
Press an extension button + #490 + n + #, where n is the music source 1~15.
Press BGM. LED turns off. Or,
Press an extension button + #491.
The phone is in an idle state when listening to BGM. Attempting to adjust the BGM
volume at this point will result in only a ringer tone adjustment and the BGM will
restart at the beginning of the music source.
BGM volume can only be adjusted when the phone is in use. The 'in use' state is
when a call is being received or dialed.
To change the volume of the BGM, press the PDN key, this interrupts the BGM
and initiates the 'in use' state. When you hear the dial tone, use the Vol key to
adjust the tone up or down. Press the PDN key again to return to the BGM in
progress.
Two types of Call Forwarding may be set:
System Call Forward – automatically directs calls to a predefined location, such
as Voice Mail or a DN. System Call forward is set via system programming; please
see your system administrator to modify this feature.
Station Call Forward – is used to replace a System Call Forward destination with
a custom Call Forward setting made from a base station, however, voice-first calls
may not be forwarded using this feature.
Check with your System Administrator to determine if the
Important!
system uses a feature called "Basic Survivability". If so, DO
NOT make any changes to Station Call Forward settings.
System Call Forward directs calls to a destination preset by an administrator for
each telephone. This is normally set to send the call to voice mail.
To turn on System Call Forward press #620. Three short tones emit
•
and "DATA PROGRAMMED" is displayed confirming entry
To turn off System Call Forward, press #621. Three short tones emit
•
and "DATA PROGRAMMED" is displayed confirming entry
Station Call Forward allows the user to re-program a base station to override the
System Call Forward button assignments. The direct extension buttons are
programmed at the system level, however, they may be modified by the user for
whatever Call Forward features they choose. These are normally the extensions
dialed most frequently, or an external number.
Call Forward features may also be programmed using IPedge Enterprise
Manager. Note that Call Forward settings must be assigned prior to receiving any
call.
TOSHIBA
IPedge
Feature Operations
41