Setup Utility - NEC Express5800 User Manual

Setup Utility

This section describes the RAID configuration tool, LSI Software RAID Configuration Utility.
Running LSI Software RAID Configuration Utility
1.
When the following screen appears after you have powered on the server, press Esc.
The POST screen appears.
2.
Check the description as shown below on the POST screen, then press Ctrl + M.
LSI Software RAID Configuration Utility starts.
NOTE:
LSI Software RAID Configuration Utility.
LSI Software RAID Configuration Utility TOP Menu (Management Menu)
LSI SoftwareRAID BIOS Version xxxxxx
LSI MPT RAID Found at PCI Bus No:xx Bev No:xx
Scanning for port 00 Responding xxxxxxxx xxxxMB
Standard FW xxx DRAM=128MB(SDRAM)
xx Logical drive(s) Configured
Press <Ctrl><M> to Run LSI Software RAID Configuration Utility
At least one hard disk drive must be connected to launch the
Configuring Your Server 4-41