2-6 General Description
1
AC inlet
The AC inlet is connected with the power cord.
2
Fixing screws
Secures the left side cover.
3
Cover lock plate
Installing a theft prevention device
protects the internal components of the
server from being stolen.
4
Mouse connector
The mouse connector is connected with the mouse coming with the server.
5
Keyboard connector
The keyboard connector is connected with keyboard coming with the server.
6
USB connectors
The USB connectors are connected with devices accepting the USB interface.
7
Serial port A connector
The serial port connector is used to connect the server to a device with the serial interface. The
server cannot be directly connected to a leased line through the connector.
Note: If N8117-01A is connected, the connector on N8117-01A side becomes serial port B
connector.
8
Parallel port connector
The parallel port connector is connected with a printer with the Centronics interface.
9
Display connector
The display connector is connected with the display unit.
10
LAN connector
The LAN connector is connected with a network system on LAN (1000BASE-T/100BASE-
TX/10BASE-T). The value following the bold-faced number indicates the port number.
Link/ACT lamp
11
The Link/ACT lamp shows the LAN access status.
12
1000/100/10 lamp
1000/100/10 lamp indicates the LAN transfer rate.
13
Dump switch
Press this switch when collecting memory dump.
NOTE: Consult with your service representative before collecting memory dump. Collecting
memory dump while the server is in the successful operation may affect the system operation.