6.1.5
Control Panel ASSY
(1) Remove three screws from the control panel ASSY.
(2) Pull up the rear end of the control panel ASSY and turn it up slightly.
NOTE: Do not pull the control panel ASSY away from the machine since it is connected to
the machine with a short LCD flat cable
(3) While holding the control panel ASSY at an angle of approx. 45°, disconnect the panel-
main harness, touch panel harness
main PCB.
NOTE: After disconnecting the flat cable(s), check that each cable is not damaged at its
end or short-circuited. When connecting the flat cable(s), do not insert it at an angle. After
insertion, check again that it is not at an angle.
Panel-main harness
Touch panel harness
Upper cover
"a"
2
*
Main PCB
Connector for
*
touch panel harness
*1
and harnesse(s).
*2
, grounding wire
Control panel ASSY
"a"
2
"a": Taptite, bind B M3x10
"b": Taptite, cup S M3x6
6-27
*1 For models with color LCD
*2 For models with touch panel
*2
, and LCD flat cable
"a"
LCD flat cable
Grounding wire
"b"
2
*
Connector for
LCD flat cable
Connector for
panel-main harness
*1
from the
1
*
2
*
1
*
(6_33)
Confidential