Stop Watch Function; Countdown Function - Silvercrest SWEP 500 A1 Operating Instructions Manual

Stop watch function

The stop watch function is only available when the radio is switched off.
• Press and hold down the
shows 0.00 0 U.
SNOOZE
• Press
is 39 minutes and 59 seconds. If the stopwatch exceeds the maximum
time, the indicator 39:59.0 appears and flashes in the display.
• During time measurement, it can be stopped by pressing
SNOOZE
• Pressing
• Hold down
• Leave the stop watch by pressing

Countdown function

The countdown function is only available when the radio is switched off.
Set and save countdown
• Press and hold down the
the screen shows 0.00 D. The D blinks.
UP
• Press the
5 countdown times are preset on the memory buttons and you can open
these directly using the corresponding memory button:
M.0/5
Button
M.2/7
Button
M.4/9
Button
MEM
• Press the
MEM
flashes on the screen. Now use the
a memory space; when you press the relevant memory key the time is
saved in this memory space and the time previously stored there
overwritten. Pressing the
MEMORY SCAN
• When the
countdown mode.
PAGE
to start the stop watch. The maximum time for the stop watch
again restarts the stop watch.
SNOOZE
to reset the stop watch.
MEMORY SCAN
DOWN
or button to set the desired time.
5:00
15:00
25:00
button to save the set time, the memory space indicator
MEM
button is pressed again you leave the
button for around 2 seconds, the screen
PAGE
.
button for around 2 seconds,
M.1/6
Button
M.3/8
Button
M.0/5
–
button again will save the set time.
- 21 -
GB/CY
SNOOZE
10:00
20:00
M.4/9
buttons to select
.