Gasket Assembly; Remove And Re-Install - Electrolux EI15TC65HS Technical & Service Manual

Gasket Assembly

REMOVE AND RE-INSTALL

The gasket is made of a fl exible vinyl material with
imbedded magnets. Over time it may become brittle or
cracked, and lose its fl exibility. If this happens the door
may not close properly, so replace the gasket.
TRIM
COVER
RETAINER
STRIPS
SCREWS
CABINET
GASKET
Section B – Cabinet
1. Remove door assembly (see Door Assembly, Remove
and Re-install).
2. Remove control panel (see
Control Panel Assembly).
3. Lift the outer edge of the gasket to expose the
retainer strips and the screws that are used to fasten
the strips to the cabinet. NOTE: There are six retainer
strips: two each on the top and bottom and one each
for the left and right sides.
4. Remove the Phillips head screws that secure the
retainer strips to the cabinet; then remove the strips
from underneath the gasket. Pull the gasket off of the
cabinet.
5. To install a new gasket, place retainer(s) under the
outer edge of the gasket, then use the screws to
fasten the retainers and gasket to the cabinet.
6. Re-install the control panel.
Electrical Components,
13