Power Cable; Remove And Replace - Electrolux EI15TC65HS Technical & Service Manual

Section D – Electrical Components
SCREWS
4. Remove two Phillips head screws (in above illustration,
shown in place from the top) from the bottom of the
right stabilizer plate and remove the odor disk gear
motor.
5. Reassemble unit in reverse order.

Power Cable

REMOVE AND REPLACE

If the power cable becomes worn or frayed, replace it.
GROUND
GROMMET
SCREW
1. Remove the back panel from the compactor (see
Access to Components, Remove Cabinet Cover).
2. Rotate the power cord grommet 90° and slide it out
of the slot in the cabinet frame.
3. Remove the screw securing the cord's green ground
wire to the frame.
4. Cut the black and white power cord wires beyond the
crimp connectors and remove the cord.
5. Strip, connect and crimp the black and white wires
of the replacement cord to the unit per the electrical
schematic on the inside of the back panel (or in this
manual).
6. Attach the cord's green ground wire to the top frame,
and secure with the original screw.
The standard color coding for safety ground wires
is GREEN, or GREEN WITH YELLOW STRIPES.
Ground leads are not to be used as current-carrying
conductors. It is EXTREMELY important that the
service technician re-establish all safety grounds
prior to completion of service. Failure to do so will
create a hazard.
7. Install the grommet on the cord and insert in cabinet
frame.
8. Re-install back panel.
33