Electrolux EI15TC65HS Technical & Service Manual page 24

24 Section D – Electrical Components
6. Remove six Phillips head screws each that secure the
front and rear of the stabilizer plates to the cabinet
cover (rear view shown).
GROMMET
7. To remove the power cord at the back of the unit,
rotate the power cord grommet 90º to the right, then
slide the cord out of the slot. Temporarily place the
cord in the rear of the power unit assembly to keep it
out of the way.
SCREWS
SCREWS
8. Remove fi ve Phillips head screws each from the
lower right and left sides of the cabinet cover.
STABILIZER
PLATES
9. Gently spread lower left and right sides of the cabinet
cover apart and raise a few inches to allow the left
and right stabilizer plates to be removed. Take care
not to damage or tear the gasket. Tilt the bottom front
of the cabinet cover forward and up while raising the
cover.
10. Grasping the front and rear edges of the cover, raise
it up a few inches and allow it to rest temporarily
on the four locator pins. Remove the left and right
stabilizer plates. Again grasp the front and rear edges
of the cover and lift it off the unit, tilting it forward and
back as required.