Re-Install Cabinet Cover; Control Panel Assembly; Remove And Re-Install - Electrolux EI15TC65HS Technical & Service Manual

Hide thumbs Also See for EI15TC65HS:

Table of Contents

Section D – Electrical Components

RE-INSTALL CABINET COVER

PINS

1. To re-install the cabinet cover, lift the cover over the

top of the unit and allow it to rest temporarily on the

top of the locator pins.

Insert the right and left stabilizer plates but do not

secure them in place (they will rest temporarily on

top of the ram). Gently move the cover so that the

front and rear pins slide into their respective rubber

grommets. On ICON models, make sure the sound-

deadening material ﬁ ts properly down the sides of

the cabinet.

Using six Phillips head screws (front and rear), secure

the three stabilizer plates to the cabinet. NOTE: The

stabilizer plates rest below the front and rear cross-

members (see illustration above).

Re-install the bag storage, control panel, cabinet

cover, bucket and door, etc., in reverse order.

The control panel assembly houses the display panel, the

safety interlock switch, the battery backup compartment,

the bag storage, and the odor control disk tray.

SCREWS

CONTROL

PANEL

Table of Contents

E15tc75hps E15tc75hss