Access To Components; Remove Cabinet Cover - Electrolux EI15TC65HS Technical & Service Manual

Section D – Electrical Components

Access to Components

In order to access the electrical components, it is fi rst
necessary to remove the cabinet cover.

REMOVE CABINET COVER

1. Remove the bucket from the compactor (see
Trash Bucket).
2. Remove the door assembly, the (2) bottom door
gasket retainers (see Cabinet, Door Assembly).
3. Remove the back panel by fi rst removing the Phillips
head screw that secures the power cord cable clamp
to the back panel, and then removing the 16 screws
that secure the panel to the cabinet.
SCREWS
BAG
STORAGE
CONTROL
SCREWS
PANEL
SCREWS
4. Remove control panel assembly (see Control Panel
Assembly, Remove and Re-install).
Cabinet,
SCREWS
BACK
PANEL
SCREW
NOTCH
CABLE
CLAMP
5. To remove the bag storage, remove four Phillips head
screws that secure it to the cabinet. NOTE: Upon
reassembly, the notches on the right and left sides
must appear on the lower part of the bag storage.
SCREWS NOTCH
23