Section A - Installation; Free-Standing; Built-In Installation; Mounting Straps - Electrolux EI15TC65HS Technical & Service Manual

Your compactor has been designed to require minimum
space without loss of capacity whether free-standing or
built-in.

Free-Standing

As shipped, the compactor is only confi gured for built-in
installations. This appliance can be converted from built-
in to free-standing with the use of Toe Kick Accessory Kit
Model ETC15TKH (sold separately).
If additional cord length is required for free-standing
installation, remove the cord clamp and wire tie on the
back of the unit.
CAUTION
Failure to use Toe Kick Assembly Kit Model
ETC15TKH in a free-standing installation may cause
the compactor to be unstable during operation.
Section A – Installation

Built-in Installation

MOUNTING STRAPS

COMPACTOR
FRONT OF
COMPACTOR
Two under-counter mounting straps are provided. Use
these straps to secure the compactor to the underside
of a countertop.
Fasten the slotted end of the straps to the compactor
using the holes in the top of the compactor cabinet as
shown.
NOTE: When installation compactor under granite or
solid surface countertops, bend the mounting straps so
they can be secured to the adjacent cabinetry.

UNDER-COUNTER OPENING

34
ELECTRICAL
The compactor requires an under-counter opening 15-in.
wide, 34-5/8-in. high, and 24-in. deep.
Plan to provide an electrical outlet in the opening that
meets all applicable electrical codes and requirements.
See "Grounding Instructions" on Page 2 for specifi c
information.
TOP OF
15" W
24" D
5
/ " H
8
12" MIN
Opening
15" Wide
OUTLET
34-1/2" High
22" Deep
5