Complete Power Unit Mechanism; Remove And Re-Install; Drive Wheels; Remove And Replace - Electrolux EI15TC65HS Technical & Service Manual

18 Section C – Power Unit Mechanism
Complete Power Unit
Mechanism

REMOVE AND RE-INSTALL

The complete power unit mechanism consists of the ram
screw assemblies, the motor and the drive belt. Rather
than replace individual components, it may be easiest to
replace the whole mechanism.
1. Remove cabinet cover (see
Access to Components).
2. Mark the location of all wire ties.
3. Support the power unit and remove the two Phillips
head screws from each of four support rods.
4. Remove the power unit mechanism.
5. Installation is the reverse of removal.

Drive Wheels

REMOVE AND REPLACE

SCREWS
SUPPORT
ROD
Electrical Components,
1.
SCREWS
2.
3.
Remove cabinet cover (see
Access to Components).
Remove the belt cover and drive belt (see above)
and follow the steps in Drive Belt, Remove and
Re-install.
Remove spring washer, bearing and thrust washer
from each drive wheel and remove both drive wheels.
NOTE: Grease the spring washer, bearing and thrust
washer before re-installing.
SPRING
WASHER
BEARING
THRUST
WASHER
DRIVE
WHEEL
IDLER
WHEEL
3 SCREWS
MOTOR
Electrical Components,