Display Module Assembly; Remove And Re-Install - Electrolux EI15TC65HS Technical & Service Manual

26 Section D – Electrical Components
1. On the front of the unit, remove the fi ve Phillips head
screws that secure the control panel assembly to the
cabinet cover.
2. After removing these fi ve screws, pull the panel
away from the cabinet and disconnect the two wiring
harnesses. On ICON™ models, disconnect a third
wiring harness.
3. Installation is the reverse of removal.
SCREWS
WIRING
HARNESSES
WIRING
HARNESSES
(ICON™ ONLY)

Display Module Assembly

REMOVE AND RE-INSTALL

The display module assembly contains switches and LEDs
that allow the operator to turn the compactor ON and
OFF, and to place it in LOCK mode; to select HOLD or
NORMAL mode; to start the compactor cycle; to set the
clock and delay mode; and on ICON models to monitor odor
control, and to reset and advance the odor control disk. If
LEDs or switches are worn, replace the display module.
1. Remove the control panel assembly from the unit (see
Control Panel Assemby, Remove and Re-install).
ODOR DISK
SWITCH
(ICON™ ONLY)
2. Disconnect the battery connector and odor disk
switch (ICON models only) from the control panel.
SCREWS
3. Remove fi ve Phillips head screws and the display
module assembly from the control panel.
4. Installation assembly is the reverse of removal. NOTE:
First install display module assembly to panel, then
re-attach wiring.
BATTERY
CONNECTOR