Calling Party Control (Cpc) Signal Detection; Cpc Signal Detection Incoming Set - Panasonic KX-TD816 Installation Manual

405

CPC Signal Detection Incoming Set

Description
Selection
Default
Programming
Conditions
Feature References
4-82 System Programming
4.5 CO Line Programming
Assigns the expected minimum duration of the CPC Signal on
incoming CO calls. If this is programmed, the system disconnects
the line when the CPC Signal is detected.
• CO line number:
KX-TD816 – 01 through 08,
KX-TD1232 – 01 through 24,
• Time (milliseconds): Disable (no detection) / 100 / 200 / 300 /
Model Number
KX-TD816BX/HK/ML/NZ
KX-TD1232(D)BX/HK/ML/NZ/(D)X
KX-TD816C/1232C
1. Enter 405.
Display : CPC Detection
2. Press NEXT.
Display: CO Line NO?—>
3. Enter a CO line number.
To enter CO line number 01, you can also press NEXT.
Display example: CO01:400msec
4. Keep pressing SELECT until the desired time is displayed.
5. Press STORE.
6. To program another CO line, press NEXT or PREV, or
SELECT and the desired CO line number.
7. Repeat steps 4 through 6.
8. Press END.
• In the case of KX-TD1232, CO01 through CO12 are for the Master
System and CO13 through CO24 are for the Slave, if available.
• To assign all CO lines to one selection, press the
this case, the display shows the contents programmed for CO01.
• You may disable CPC Signal Detection for a CO line.
• Program [415] "CPC Signal Detection Outgoing Set" is used to
program CPC Signal Detection for outgoing CO calls.
Section 3, Features,

Calling Party Control (CPC) Signal Detection

Direct Inward System Access (DISA)
*
400 / 500 / 600
All CO lines – Disable
All CO lines – 400 ms
*: Available for KX-TD1232 only.
( =all CO lines)
( =all CO lines)
Default
key at step 3. In