Panasonic KX-TD816 Installation Manual page 87

2.4.4 Installing Expansion Unit
(KX-TD170 / KX-TD180)
KX-TD1232
KX-TD1232DBX/DX
KX-TD1232BX/C/HK/ML/NL/NZ/X
KX-TD1232DBX/DX
KX-TD1232BX/C/HK/ML/NL/NZ/X
1. Loosen two screws on the cover plate.
Insert fingers into the slits to remove the
cover plate.
Slit
Note There are three cover plates. Any of
them can be removed, as needed.
The following procedures can be used to install either 8-Station
Line Unit (KX-TD170) or 4-CO Line Unit (KX-TD180) for KX-
TD1232. The KX-TD170D and the KX-TD180D are available for
the KX-TD1232DBX/X only. The model numbers of the main
units and expansion units to be used are shown below.
• 4-CO Line Unit
Main Unit
• 8-Station Line Unit
Main Unit
The following steps 1 through 5 and 7 through 10 are common to
both expansion cards.
The step 6 shows four different methods to install respective
expansion units.
Slit
Expansion Unit
KX-TD180D (4-pin Connector)
KX-TD180 (Modular Connector)
Expansion Unit
KX-TD170D (6-pin Connector)
KX-TD170 (Amphenol Connector)
2. Connect the cabinet cord to the
connector in the main unit firmly.
Installation 2-55