Panasonic KX-TD816 Installation Manual page 92

2.4.4 Installing Expansion Unit
(KX-TD170 / KX-TD180)
Amphenol 57JE Type (screw-attach-type 50-pin connector) Connection
for KX-TD170
1. The 50-pin connector (Jack) on the
Expansion Unit has two hook-pins.
Remove the upper hook-pin, taking out
the screw.
50-pin
connector
Note
When connecting a connector of the type
shown below, unscrew the lower hook-pin,
too. Then drive both accessory screws.
50-pin
connector
2-60 Installation
To fix the Amphenol 57JE type (screw-attach type 50-pin
connector) to the 8-Station Line Unit, follow the procedures below.
2. To attach the Amphenol 57JE type (Plug) to
Screw
Hook-pins
Accessory screw
Amphenol 57JE type
Accessory
screw
the connector, drive the accessory screw at the
upper part.
Fasten the accessory wire tie around the lower
hook-pin and the Amphenol 57JE type, as
shown.
Amphenol 57JE type
Accessory wire tie
57JE type
Hook-pin
Accessory
wire tie
Accessory screw