Drum Unit Replacement
Replacement Drum Kits for
STORAGE NOTES:
your TOSHIBA facsimile in-
clude a Drum Unit.
Your TOSHIBA facsimile has
been designed to display a two-
stage alert to replace the Drum
Unit once it has been depleted.
The first stage is a "DRUM
UNIT WARNING" notice. This
message is displayed when the
remaining drum life reaches
4,000 sheets. When this mes-
sage is displayed, we recom-
mend ordering and replacing
the drum at your convenience.
(If "auto supply order" (page
231) is set, you don't need to
order a replacement drum.) The
unit will continue to receive and
print facsimile messages dur-
ing this stage.
The second stage is the "RE-
PLACE DRUM UNIT" notice.
When this message is dis-
played, the machine can no
longer print documents. Recep-
tions will be stored in memory
until the Drum Unit has been
replaced.
1
The Drum Unit is a very im-
portant part of this facsimile.
Handle it with care as shown
below.
Keep the Drum Unit within a
temperature range of 0-35°C
(32-95°F) and a humidity
range of 20-80%RH (without
condensation).
Do not store or use the Drum
Unit in an environment where
the temperature changes ex-
Hold the Front Cover by the
cessively.
grips on both sides of its upper
part and pull it down to open it.
Do not touch the light sensi-
tive drum because its sur-
NOTE:
face will be easily damaged.
Do not pull the Front Cover
Do not place the light sensi-
too strongly when opening
tive drum in a location where
it.
it is exposed to direct sun-
light or high intensity light
(more than 200 lx) such as
near a window.
2
Open the Front
Remove the Process
Cover
Unit
Lift up and holding the green
handle, gently pull out the Pro-
cess Unit.
CAUTION:
Always hold the Process
Unit by the green handle.
Detach the Toner
3
Cartridge from the
Drum Unit
Move the lever of the Toner
Cartridge in the direction of the
arrow to detach it from the
Drum Unit.
NOTES:
•
Keep the Toner Cartridge
level with the Drum Unit
when they are detached.
•
Do not touch the PC Drum
under the lid of the Drum
Unit. The image quality
could be degraded.
•
Do not touch the metal area
of the Toner Cartridge. It
could be damaged due to
electrostatic interference.
3 1