D-Link DES-1228/ME Reference Manual page 139

show bandwidth_control
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display bandwidth control settings:
DES-1228/ME:5#show bandwidth_control 1-5
Command: show bandwidth_control 1-5
Bandwidth Control Table
Port RX Rate
(Kbit/sec)
---- ----------
1 no_limit
2 no_limit
3 no_limit
4 no_limit
5 no_limit
DES-1228/ME:5#
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Used to display the bandwidth control table.
show bandwidth_control {<portlist>}
This command is used to display the current bandwidth control
configuration on the Switch, on a port-by-port basis.
Note: Effective RX/TX
The actual bandwidth will be an adjusted value based on the user
specified bandwidth. The actual limit may be equal to the user
specified limit, but will not exceed it. The actual limit recognized by
the device, will be displayed when the command is executed.
<portlist> − Specifies a port or range of ports to be viewed.
None.
TX Rate
(Kbit/sec)
----------
no_limit
no_limit
no_limit
no_limit
no_limit
Effective RX
(Kbit/sec)
----------------
no_limit
no_limit
no_limit
no_limit
no_limit
135
Effective TX
(Kbit/sec)
-------------
no_limit
no_limit
no_limit
no_limit
no_limit