Switch Utility Commands - D-Link DES-1228/ME Reference Manual

The Switch Utility commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table:
Command
download
config firmware
show firmware information
show config
upload
enable autoconfig
disable autoconfig
config autoconfig timeout
show autoconfig
ping
ping6
traceroute
config terminal _line
show terminal_line
Each command is listed, in detail, in the following sections:
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameters
[ firmware_fromTFTP [<ipaddr> | <ipv6addr>] <path_filename
64> image_id <value 1-2> | cfg_fromTFTP [<ipaddr> |
<ipv6addr>] <path_filename 64> {config_id <value 1-2> |
increment} ]
image_id <value 1-2> [delete | boot_up]
[current_config | config_in_nvram]
[cfg_toTFTP [<ipaddr> | <ipv6addr>] <path_filename 64>
{config_id <value 1-2>} {[include | exclude | begin] <filter_string
80> {<filter_string 80> {<filter_string 80>}} {[include | exclude |
begin] <filter_string 80> {<filter_string 80> {<filter_string 80>}}
{[include | exclude | begin] <filter_string 80> {<filter_string 80>
{<filter_string 80>}}}}} | log_toTFTP [<ipaddr> | <ipv6addr>]
<path_filename 64>]
< value 1-65535 >
<ipaddr> {times <value 0-255>} {size <value 1-60000>}
{timeout <sec 1-99>}
<ipv6addr> {times <value 1-255>} {size <value 1-6000>}
{timeout <value 1-10>}
<ipaddr> {ttl <value 1-60>} {port <value 30000-64900>}
{timeout <sec 1-65535>} {probe <value 1-9>}
[default | <value 20-80>]
S U
WITCH
73
9
C
TILITY OMMANDS