D-Link DES-1228/ME Reference Manual page 398

debug config error_reboot
Description
Parameters
Restrictions
Example usage:
To set the switch to not need a reboot when a fatal error occurs:
DES-1228/ME:5# debug config error_reboot disable
Command: debug config error_reboot disable
Success.
DES-1228/ME:5#
debug show error_reboot state
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show the error reboot status:
DES-1228/ME:5# debug show error_reboot state
Command: debug show error_reboot state
Error Reboot: Enabled
DES-1228/ME:5#
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Set if the switch needs to be rebooted when a fatal error occurs.
enable − Need to reboot the switch when fatal error happens (if the
project does not define the default setting, enable for default).
disable − Does not need to reboot the switch when fatal error
happens, system will hang-up for debug and enter the debug shell
mode for debug.
Only Administrator-level users can issue this command.
Use the command to show the error reboot status.
debug show error_reboot state
Show the error reboot status.
None.
Only Administrator-level users can issue this command.
394