D-Link DES-1228/ME Reference Manual page 285

Usage example:
To display the SSH server:
DES-1228/ME:5# show ssh server
Command: show ssh server
SSH Server Status
SSH Max Session
Connection Timeout
Authenticate Failed Attempts
Rekey Timeout
Listened Port Number
DES-1228/ME:5#
config ssh user
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the SSH user:
DES-1228/ME:5# config ssh user Zira authmode password
Command: config ssh user Zira authmode password
Success.
DES-1228/ME:5#
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
: Disabled
: 8
: 120 (sec)
: 2
: never
: 22
Used to configure the SSH user.
config ssh user <username 15> authmode [hostbased [hostname
<domain_name 32>] [hostname_IP <domain_name 32> <ipaddr>] |
password | publickey]
This command is used to configure the SSH user authentication
method.
<username 15> − Enter a username of no more than 15 characters to
identify the SSH user.
authmode – Specifies the authentication mode of the SSH user wishing
to log on to the Switch. The administrator may choose between:
hostbased – This parameter should be chosen if the user wishes to
use a remote SSH server for authentication purposes. Choosing
this parameter requires the user to input the following information
to identify the SSH user.
hostname <domain_name 32> − Enter an alphanumeric string of up to 32
characters identifying the remote SSH user.
hostname_IP <domain_name 32> <ipaddr> − Enter the hostname and the
corresponding IP address of the SSH user.
password – This parameter should be chosen to use an
administrator defined password for authentication. Upon entry of
this command, the Switch will prompt the user for a password,
and then to retype the password for confirmation.
publickey – This parameter should be chosen to use the publickey on
a SSH server for authentication.
Only Administrator level users can issue this command.
281