Toshiba e-STUDIO167 Service Manual page 163

[L] Pickup roller
(1) Take off the drawer.
(2) Rotate the pickup roller shaft counterclock-
wise to make the rubber surface of the roller
facing down.
Note:
Because the tension is applied to the pickup
roller shaft by the pickup clutch when it is
rotated counter-clockwise, be sure to hold
the shaft while replacing the roller.
(3) Push 2 latches each to take off 2 pickup roll-
ers.
Notes:
• Be sure to install the pickup roller in the
correct direction when reassembling it.
• When it is difficult to take off the pickup
roller, alternatively follow the procedure
below to remove it.
1. Take off the damp heater unit or
dummy plate.
P.10-19 "[J] Damp heater unit (DH3) /
Dummy plate"
2. Take off 2 pickup rollers by releasing 2
latches each.
[M] Registration roller clutch (CLT1)
(1) Take off the rear cover.
P.2-22 "[J] Rear cover"
(2) Remove 2 screws and take off registration
roller holder.
Note:
When installing the registration roller holder,
engage the arm of the registration roller
clutch with the rotation stopper of the regis-
tration roller holder.
© February 2007 TOSHIBA TEC CORPORATION All rights reserved
Fig. 10-35
Pickup roller
Fig. 10-36
Registration roller holder
Rotation stopper
Fig. 10-37
10 - 21
Pickup roller
e-STUDIO167/207/237
PAPER FEEDING SYSTEM
10