Message - Toshiba e-STUDIO167 Service Manual

5.2.2

Message

No. Message
1 Wait warming up
2 READY
3 COPYING
4 Saving energy
5 Select original size
6 -
7 Cassette * empty
8 Toner empty
9 Misfeed in bypass
10 Misfeed in copier
(Copier machine)
11 Misfeed in doc. Feeder
(ADF)
12 Misfeed in duplexer
(ADU)
13 Call for service
14 Time for maintenance
© February 2007 TOSHIBA TEC CORPORATION All rights reserved
Condition of machine
Being warmed up
• Displayed after the main switch is
turned ON up until the machine
becomes ready for copying
Standby for copying
• The machine is ready for copying
and operator's instructions on copy-
ing conditions can be input
• Returns to the default condition if
no key is pressed for the setting
time of auto clear timer
Now copying
• Displayed by pressing the START
key
• Copy quantity indicator becomes
"ex. 3o 2 o 1o 3" and copying is
completed
Energy saver conditions
Platen sort copying standby state
Timer off
• No message is displayed in the dis-
play panel
Indication of lack of paper
• Indicates when there is no paper in
cassette
• Bypass copying is possible
Indication of lack of toner
• The toner in the toner cartridge
becomes empty
• When this message is displayed, it
is not possible to copy
Bypass paper jamming (SFB)
• Paper jams at the bypass tray
Paper jammed in the machine
Original jammed
• An original is jammed in the ADF
Paper jammed in the ADU
Some part of the mechanism, motors,
switches or sensors is abnormal
Indication of PM cycle
• Displayed when it is time for pre-
ventive maintenance and inspection
• Capable of copying
5 - 3
Notes
-
• Copy quantity indicator shows
"1"When a digital key is pressed,
that number indicates the set quan-
tity
• The set quantity can be cleared to
"1" by pressing the CLEAR/ STOP
key
• Bypass copying is possible
• After completion of copying, the
copy quantity indicator returns to
the initially set number
• Reset by pressing the any key
except the ENERGY SAVER key
• When using original cover
-
• Supply paper to the selected cas-
sette
• Select another cassette
• Reset after the toner is supplied
and the front cover is closed
The machine returns to normal condi-
tions automatically when the paper out
is pulled from the bypass tray
Remove the paper jammed in the
copier by following the messages
Open the ADF jam access cover and
the ADF unit, and remove the jammed
original
Remove the paper jammed in the
copier by following the message
Turn OFF the machine, remove the
cause of the fault and turn the machine
back ON
Maintenance and inspection by a quali-
fied service technician
e-STUDIO167/207/237
CONTROL PANEL
5