Toshiba e-STUDIO167 Service Manual page 204

[B] Developer material
(1) Take out the developer unit
P.12-11 "[A] Developer unit".
(2) Remove 2 screws and slide the developer
unit upper cover to the direction of the arrow
and take it off.
Note:
When installing the developer unit upper
cover, make sure that the side seal comes
between the developer unit upper cover and
rubber seal on the cover.
(3) Remove the developer material from rear
side.
Note:
When removing the developer material, be
careful not to drop the developer material on
the gears of the developer unit.
e-STUDIO167/207/237
DEVELOPMENT SYSTEM
Developer unit upper cover
Rubber seal
Developer unit
upper cover
© February 2007 TOSHIBA TEC CORPORATION All rights reserved
12 - 12
Fig. 12-8
Side seal
Fig. 12-9
Fig. 12-10