Toshiba e-STUDIO167 Service Manual page 228

(5) Remove 1 clip and 1 bushing.
(6) Take off the exit roller by sliding it to the rear
side.
[D] Exit sensor (S5)
(1) Take off the fuser/paper exit unit.
P.13-12 "[A] Fuser / Exit unit"
(2) Release the stopper using a flathead screw-
driver.
(3) Open the guide and slide it to the front side.
Then slide its rear hinge downward.
Note:
Keep the guide being slid to the front side
during the steps (3) and (4).
e-STUDIO167/207/237
FUSER / EXIT UNIT
Exit roller
© February 2007 TOSHIBA TEC CORPORATION All rights reserved
13 - 14
Clip
Bushing
Fig. 13-12
Stopper
Stopper
Fig. 13-13
1
Guide
Fig. 13-14
2