Bypass Feed Copying; Interruption Copying - Toshiba e-STUDIO167 Service Manual

4.2.4

Bypass feed copying

1) Insert a sheet of paper into the bypass tray.
o Bypass paper sensor ON
- Bypass feed priority state.
2) Press the [START] button
o "READY" Æ "COPYING"
o CIS LED ON
o Scan motor ON o CIS unit move forward
o Polygonal motor rotates in high speed
o Main motor and exit motor ON
- The drum, fuser unit, developer unit and exit roller are driven.
3) Bypass feeding
o Main charger, developer bias and discharge LED ON. Fans are rotated in high speed.
o Bypass pickup solenoid ON
- The bypass pickup roller start to rotate.
- The bypass pickup roller is lowered.
- The bypass feed roller start to rotate.
o Paper reaches the registration roller
o Aligning operation
o After a certain period of time, the bypass pickup solenoid OFF
4) Hereafter, the operation 3) through 6) of
4.2.5

Interruption copying

1) Press the [INTERRUPT] button
o LED "INTERRUPT" ON
o Copying operation in progress is temporarily stopped. CIS unit return to appropriate positions
o "Job interrupted" is displayed
o Automatic density and reproduction ratio 100% are set (The set number remains the same)
2) Select the desired copy condition
3) After the interruption copying is finished:
o LED "INTERRUPT" OFF by pressing the [INTERRUPT] button
o "READY to resume job" is displayed
4) Press the [START] button
o The copying operation before the interruption is resumed
e-STUDIO167/207/237
GENERAL OPERATION
P.4-3 "4.2.3 Drawer feed copying" is repeated.
© February 2007 TOSHIBA TEC CORPORATION All rights reserved
4 - 4