Table 1.33 [System Setup] Window Button - Fujitsu PRIMEQUEST 2000 Series Tool Reference

MMB Web-UI (Web User Interface) Operations
1.2 [System] Menu for PRIMEQUEST 2400E2/2800E2/2400E/2800E
Items
Reserved SB Force
Power Off Wait
System Power Save
Control
System Power Saving
Threshold
Buttons
Apply When items such as [Power Feed Mode] and [Power Restore Policy] are specified and [Apply]
button is clicked, the information is set.
Cancel When [Cancel] button is clicked, returns to the original status without setting the changed or
input items.
(1) Menu Operation
[System] – [System Setup]
(2) Window Operations
Specify the items such as [Power Feed Mode] and [Power Restoration Policy] and click on the [Apply]
button.
Respective information is set.
[Message]
This section describes the messages to be displayed on this window.
Message Number
I_00013 Setting completed.
E_00100 Failed to set the System Setup
W_00426 Invalid values specified.
E_00098 Failed to get the system configuration.
W_00559 Unable to set Power Save Control because PSU type is not PSU_P.
E_00100 Failed to set the system config .
For details on the messages displayed on the window, see
(CA92344-0540CA92344-0540).
While switching to Reserved SB, sets the maximum standby time till the start of
force power off of partition which includes the concerned SB. Specifies within the
range of 0~99 minutes.
Default is 10 minutes.
Sets enable/disable for Power Saving function for entire system.
·
Enable
·
Disable
Power Saving function supports only PSU_P 200V.
Default is Disable.
Sets the power consumption threshold (Limit value) of entire system.
Minimum value is 3200W.
Maximum value is as shown below.
·
PRIMEQUEST 2400E2/2400E : 8640W
·
PRIMEQUEST 2800E2/2800B2/2800E/2800B : 8640W
Setting is possible only when System Power Save Control is Enable, gray-out at
the time of disable.
Default value is the maximum value of each model.

TABLE 1.33 [System Setup] window button

91
Description
Description
Message
PRIMEQUEST 2000 Series Message Reference
CA92344-0539-04