Removing The Oven Vent (Coil Top Models And Bottom Part Of The Vent System On Smooth Top Models) - Electrolux 30" Service Manual

Removing the fan blade cover on convection and
speed bake models:
1. Remove the oven racks and the three screws
holding the cover to the rear wall of the oven.
Three screws
Removing the fan blade on convection and speed
bake models:
1. Remove the fan blade cover. Using a 1/2 inch wrench
remove the nut holding the fan blade to the motor
shaft by turning the nut counter clockwise.
1/2 inch wrench
Removing assist element on convection models:
1. Disconnect power and remove the large panel and
disconnect the wires from the element.
2. Remove the one screw at the top and two at the
bottom that hold the element to the rear oven wall
and pull the element into the oven.
Removing the oven vent: (coil top models and bot-
tom part of the vent system on smooth top models)
1. The base of the oven vent is tabbed and the top of the
oven liner is notched. Turn the base of the vent until
the tabs line up with the notches and pull the vent
into the oven.
Removing the upper oven vent: (smooth top mod-
els):
1. Disconnect power and raise the main top.
2. Lift the upper part of the vent up and unsnap vent
from bracket mounted to the rear panel of the range.
113
Three screws
Oven vent
Bracket