Removing The Oven Light Socket - Electrolux 30" Service Manual

Removing oven light shield: (self-clean models)
1. The oven light shield is held against the rear oven
wall by a wire spring clip. Unsnap the wire and the
shield will lift off.

Removing the oven light socket:

1. Disconnect power and remove the small panel from
the rear of the range.
2. From inside the oven remove the two screws
holding the socket to the oven liner, pull the socket
out the rear of the range and disconnect the wires.
Two screws
Storage drawer area
Storage drawer front panel:
1. The drawer front panel is mounted to two braces.
The braces are attached to a panel tab at the top of
the brace that goes into a slot in the flange of the
panel, and by a screw at the bottom.
Tab
Storage drawer body:
1. The storage drawer body is held to the two braces
by four screws. Remove the four screws and the
braces to remove the front panel from the drawer
body.
Two screws on each side
Removing the drawer rollers:
1. The rollers mounted to the drawer and the front
frame are held in place by rivets. To remove the
roller it is necessary to drill out the rivet. The
replacement roller will come as a kit with a roller,
nut and bolt.
Drawer roller
114
Screw
Frame roller