To Start The Delayed Self-Clean Cycle - Electrolux 30" Service Manual

To Start the delayed Self-Clean Cycle

COOK TIME and STOP TIME control the Delayed Self-Clean operation. The automatic timer will turn the oven on and off
At the time you select. If you are planning to use the oven directly after a self-clean cycle remember to allow time for the
oven to cool down and the lock to unlock. This normally takes about one hour. So if you set a 3 hour self-clean cycle, it will
be 4 hour before you can cook again.
*We recommend a 2 hour self-clean cycle for light soils, a 3 hour cycle for average soils, and a 4 hour cycle for heavy soils
(to assure satisfactory results).
During the self-cleaning cycle, the outside of the range can become very hot to the touch. DO NOT
leave small children unattended near the appliance; they may be burned if they touch the hot surfaces.
DO NOT force the oven door open. This can damage the automatic door locking system. Use care
when opening the oven door after the self-cleaning cycle. Stand to the side of the oven when opening the door to allow hot
air or steam to escape. The oven may still be VERY HOT.
Note: The oven lights will not operate during the self cleaning cycle.
To Set the Controls for the Self-Cleaning Cycle To Start
at a Delayed Time and Shut off Automatically: (example
self-clean cycle to finsh at 9:00)
1. Be sure the clock shows the correct time of day, the oven is empty and
door is closed.
2. Push Clean ; 3:00 will be displayed; START, TIMED and CLEAN will
flash. If a 2 or 4 hour clean is desired use the number pads to enter
the time. Set the cleaning time based on the amount of soil you
have - light, medium or heavy. *See above.
3. Push Stop Time . Enter the desired Stop Time using the number pads
9 0 0 .
4. Push Start .
5. As soon as the controls are set, the motor driven lock will begin to
close automatically and the LOCK indicator light will be displayed. (It
takes about 15 seconds for the lock to close.) DELAY, TIMED and
CLEAN will be displayed.
6. The control will calculate backward from the set stop time to determine
when the self-cleaning cycle should begin. The self-cleaning cycle will
come on automatically at the calculated time. At that time, the word
DELAY will go out and ON will appear.
When the Self-Clean Cycle is Completed
1. The time of day and the word LOCK will remain in the display.
2. Once the oven has cooled down for 1 hour, and the word LOCK shown
in the display has gone out, the oven door can be opened.
INSTRUCTIONS PUSH
Clean
Stop
Time
9 0 0
Start
LOCK
92
DISPLAY
:
3 00
HR
CLEAN
START
TIMED
9:00
START
STOP
TIME
1:30
TIMED
CLEAN
DELAY
LOCK
9:00
CLEAN
TIMED
LOCK
12:00
LOCK