Toro ProPass 200 Service Manual page 27

FA
S2
EC1
CONTROL
MANIFOLD
M
NOTE: The hydraulic schematic shown above includes
the hydraulic power pack as the hydraulic supply
source. If your ProPass uses hydraulic supply from the
tow vehicle, the vehicle includes the hydraulic pump, re-
lief valve and hydraulic reservoir that are used for the
ProPass.
NOTE: The rear option is either the twin spinner (two
motors) or the cross conveyor (one motor).
ProPass 200
PLUG
FB LA
CV1 CV2 CV3
SP1 SV1
S1 S2
ORF3
(0.068)
ORF1
(0.040)
P
HYDRAULIC
POWER PACK
Page 3 - - 13
PLUG
LB O T1
CV4
ORF4
(0.020)
PV1
S1
ORF2
(0.020)
T
NOTE: The hydraulic hose kit used when a ProPass re-
ceives its hydraulic supply from a tow vehicle includes
a check valve in the return hose assembly (see Hydraul-
ic Hose Kit in the General Information section of this
chapter).
FLOOR
MOTOR
SPINNER
MOTORS
CONVEYOR
MOTOR
ProPass 200
Hydraulic Schematic
Electronic Hydraulic Controls
All solenoids are shown as
de- -energized
Hydraulic System