Information - Toro ProPass 200 Service Manual

3. Remove twin spinner (or other option) from machine.
4. Thoroughly clean junction of hydraulic lines and hy-
draulic tank fittings. Disconnect hydraulic lines from
tank. Install caps or plugs in hose and tank fittings to pre-
vent contamination and leakage of hydraulic oil.
5. Place a suitable container under the hydraulic tank
to collect hydraulic oil. Remove plug (item 21) from bot-
tom of tank and drain hydraulic tank. Discard O--ring
from plug.
6. Disconnect hoses from the hydraulic fittings in tank.
Allow hoses to drain into a suitable container. Install
caps or plugs in hoses and pump fittings to prevent con-
tamination.
7. Remove two (2) flange head screws (item 22) and
flange nuts (item 2) securing the hose bracket to the hy-
draulic tank. Support the hose bracket and attached hy-
draulic hoses to prevent the assembly from falling.
8. Support the hydraulic tank to prevent it from moving.
9. Remove four (4) flange head screws (item 3) and
flange nuts (item 12) that secure the hydraulic tank to the
machine.
10.Remove hydraulic tank from the machine.
11. If fitting removal is necessary, mark fitting orientation
to allow correct assembly. Remove fittings and strainer
from hydraulic tank (Fig. 8). Discard removed O--rings.
Installation (Fig. 7)
1. If fittings were removed from hydraulic tank, lubricate
and place new O--rings onto fittings. Install fittings into
tank openings making sure that fitting orientation is as
noted during removal. Tighten fittings (see Hydraulic Fit-
ting Installation in the General Information section of
Chapter 3 -- Hydraulic System).
2. Position hydraulic tank to the machine and secure
with four (4) flange head screws (item 3) and flange nuts
(item 12).
ProPass 200
3. Align the hose bracket and attached hydraulic hoses
to the hydraulic tank bracket. Secure the hose bracket
with two (2) flange head screws (item 22) and flange
nuts (item 2).
4. Remove plugs from hydraulic hoses and tank fit-
tings. Connect hydraulic hoses to hydraulic tank fittings
(see Hydraulic Hose and Tube Installation in the Gener-
al Information section of Chapter 3 -- Hydraulic System).
5. Install new O--ring on plug (item 21) used to drain hy-
draulic tank. Install plug in tank.
6. Fill hydraulic tank with new hydraulic oil.
7. Install twin spinner (or other option) to machine.
2
4
5
12
6
1. Hydraulic tank
2. Strainer
3. O- -ring
4. O- -ring
o
5. 45 hydraulic fitting
6. O- -ring
Page 6 - - 15
9
1
3
7
10
11
8
Figure 8
7. O- -ring
8. #6 plug
9. Dipstick
10. O- -ring
o
11. 45 hydraulic fitting
12. O- -ring
Hydraulic Power Pack