Toro ProPass 200 Service Manual page 87

Disassembly (Fig. 1)
1. Position machine on a level surface. If ProPass is at-
tached to tow vehicle, apply tow vehicle parking brake,
stop engine and remove key from the ignition switch.
Chock wheels to prevent ProPass machine from mov-
ing.
2. If front rinse guard is to be removed from machine
with electronic controls (Fig. 2):
A. Disconnect E--stop button from machine wire
harness.
B. Remove fasteners that secure control panel
guard to machine. Remove control panel guard.
C. Remove the two (2) cap screws, lock washers
and flat washers that secure hydraulic control mani-
fold to rinse guard.
D. Raise and support hydraulic manifold away from
rinse guard.
3. Using Figure 1 as a guide, remove necessary bed
guards from frame to allow access to floor drive com-
ponents.
Assembly (Fig. 1)
1. Secure all removed bed guards to frame using Fig-
ure 1 as a guide.
2. If front rinse guard was removed from machine with
electronic controls, secure hydraulic manifold, control
panel guard and E--stop button to machine (Fig. 2).
ProPass 200
MACHINES WITH ELECTRONIC
HYDRAULIC CONTROLS
1
5
6
8
9
10
7
1. E- -stop button
2. Control panel guard
3. Screw (2 used)
4. Flange nut (2 used)
5. Flat washer (2 used)
6. Cap screw (2 used)
Page 5 - - 5
3
4
2
11
Figure 2
7. Hydraulic manifold
8. Cap screw (2 used)
9. Lock washer (2 used)
10. Flat washer (2 used)
11. Front rinse guard
Chassis