Service And Repairs; Engine - Toro ProPass 200 Service Manual

Service and Repairs

Engine

RIGHT
FRONT
5
21
18
1. Jaw coupling (engine)
2. Spider coupling
3. Jaw coupling (gear pump)
4. Square key
5. Engine
6. Flange adapter
7. Engine mount plate
8. Mount bracket (4 used)
Engine Removal (Fig. 5)
1. Position machine on a level surface. If ProPass is at-
tached to tow vehicle, apply tow vehicle parking brake,
stop engine and remove key from the ignition switch.
Chock wheels to prevent ProPass machine from mov-
ing.
Hydraulic Power Pack
13
6
16
15
3
2
1
4
20
18
GROUND CABLE
CONNECTION
Figure 5
9. Flange nut (2 used)
10. Cap screw (2 used)
11. R- -clamp (2 used)
12. Engine wire harness
13. Generator bracket
14. Lock nut (2 used)
15. Cap screw (2 used)
2. To prevent unexpected machine operation, discon-
nect the negative battery cable from the battery termin-
al. Position disconnected negative cable away from the
negative battery terminal.
Page 6 - - 12
14
22
18
10
11
22
18
7
9
8
19
18
17
16. Flat washer (2 used)
17. Cap screw (2 used)
18. Flat washer (10 used)
19. Flat washer (2 used)
20. Lock nut (4 used)
21. Cap screw (2 used)
22. Cap screw (4 used)
12
ProPass 200