Information; Power Pack Relief Valve - Toro ProPass 200 Service Manual

Power Pack Relief Valve

RIGHT
FRONT
1. Hydraulic relief valve manifold
2. Hydraulic hose
3. Hydraulic hose
4. Hydraulic tube
5. Hydraulic hose
Removal (Fig. 9)
1. Position machine on a level surface. If ProPass is at-
tached to tow vehicle, apply tow vehicle parking brake,
stop engine and remove key from the ignition switch.
Chock wheels to prevent ProPass machine from mov-
ing.
2. Read the General Precautions for Removing and
Installing Hydraulic System Components in the Service
and Repairs section of Chapter 3 -- Hydraulic System.
Hydraulic Power Pack
2
6
10
9
1
7
6. Cap screw (2 used)
7. Flange nut (2 used)
8. Straight hydraulic fitting (4 used)
9. Engine mount plate
Page 6 - - 20
3
12
4
5
8
Figure 12
Before disconnecting any hydraulic compo-
nents, operate all hydraulic controls to relieve
system pressure and avoid injury from pressur-
ized hydraulic oil. See Relieving Hydraulic Sys-
tem Pressure in the General Information section
of Chapter 3 - - Hydraulic System.
13
8
10. Gear pump
11. Oil filter
12. Hydraulic hose (from tank)
13. Hydraulic hose (to tank)
CAUTION
ProPass 200
11