Toro ProPass 200 Service Manual page 79

Displayed Message
ASSOC PENDING
ASSOC ACTIVE
CLR CHAN SCAN
POW UP BUNIT
ASSOC SUCCESS
ALL STORE
OPTION STORE
FLOOR STORE
PRESET 1 STORE
PRESET 2 STORE
PRESET 3 STORE
WAITING FOR BASE
COMMAND POW DOWN
LOW BAT POW DOWN
INACTIV POW DOWN
SOFTWARE VER XX
BAT XX%
BUMPS XX
CHANNEL X
HHELD ID XXXXXX
BUINT ID XXXXXX
FLRS XX%
OPTS XX%
FLR XX%
OPT XX%
SW STUCK
XXXXXX
ProPass 200
Meaning
Association between remote and base unit has yet to be made.
Association attempt between remote and base unit is in progress.
A scan to find a clear channel is in progress.
The base unit is being powered up.
Association between remote and base unit has been made.
Store all currently set values into memory.
Store the current rear option settings into memory.
Store the current floor settings into memory.
Store the current PRESET 1 setting into memory.
Store the current PRESET 2 setting into memory.
Store the current PRESET 3 setting into memory.
Remote is waiting for a response from the base unit (NOTE: Make
sure that E--Stop button is pulled out and all electrical components
are connected).
Operator has pressed the ON/OFF button to power down.
Cyclic warning that the remote batteries are low and need to be
changed.
Automatic shutdown after thirty (30) minutes of remote button in-
activity.
Software version XX is being used.
Remaining battery life in percentage.
Number of base unit messages per second being received.
NOTE: See Operator's Manual for procedure to access these dis-
play features.
Channel in Ghz currently being used for communication between
remote and base unit. NOTE: If area interference prevents reliable
remote communications, re--associating the remote to the base unit
might access different channel with less interference (see Operat-
or's Manual for association procedure).
Identity of the wireless remote. NOTE: See Operator's Manual for
procedure to access this display feature.
Identity of the base unit. NOTE: See Operator's Manual for proced-
ure to access this display feature.
Display of the stored floor speed or rear option speed percents
after initially pressing floor start or option start button. The operator
can either accept the stored setting or change it before starting the
floor or rear option by pressing the start button a second time.
During floor operation, the current floor speed in percent.
During rear option operation, the current rear speed in percent.
Remote button is stuck.
XXXXXX identifies the button that is stuck.
Page 4 - - 19 Electrical System