Ver. 3.0 - Panasonic UF-9000 Service Manual

8.1.2. Updating through the USB Port (Alternate Method)
If the device is not connected to the LAN, upgrade the firmware code using the USB Port.
1) Install the Local Firmware Update Tool to your PC
The option CD-ROM includes the Local Firmware Update Tool, and the Main Unit Firmware Code.
Please refer to the following Operating Instructions to install the Local Firmware Update Tool.
Operating Instructions:
\xFirmware\Tools\Firmup\FIRMUP OI.pdf (Refer to the
Setup:
\xFirmware\Tools\Firmup\Setup\Setup.exe
2) Preparing the Firmware Code
Double click the appropriate Destination Shortcut Batch File, and copy the Firmware Code File on the
CD-ROM to the Firmware Data Folder in your PC. Note that the files in the Archive will be extracted
automatically into the designated folder when the Archived file (.exe) is Double-clicked.
Example:
From:
Destination Shortcut Batch File: D:(CD-ROM Drive) \ xFirmware \ USA.bat
[Navy Blue Control
Firmware Code File: UF-9000_AUR_xxxxxxxx.exe or DP-190_180_AUR_xxxxxxxx.exe
[Light Blue Control
Firmware Code File:
To:
Firmware Data Folder:
3) Preparing the Main Unit for the Firmware Upgrade
Important: DO NOT connect the USB Cable yet.
Enter into Test Mode F9-07-01 to enable the unit to accept the programming code from the USB Port.
Now connect the USB Cable between the Unit, and PC.
Repeat the above steps if there are additional firmware code files to be updated.
4) Upgrading the Main Unit's Firmware Code
Start the Local Firmware Update Tool, and select the following Firmware Code Parent File Folder in
the C:\Panasonic\Panasonic-FUP\Data folder, and select the Firmware Code Type then follow the
display instructions to upgrade the Main Unit's Firmware Codes.
You must process each firmware file separately in this manner, and sequence.

Ver. 3.0

Panel]
Panel]
UF-9000_AU_xxxxxxxx.exe or DP-190_180_AU_xxxxxxxx.exe
C:\ Panasonic \ Panasonic-FUP \ Data
Local Firmware Update Tool OI
267
UF-9000
DP180/190
on the CD)
APR 2006