Installing The Hard Disk Drive Unit (Da-Hd19) - Panasonic UF-9000 Service Manual

8.4.

Installing the Hard Disk Drive Unit (DA-HD19)

8.4.1. Contents
Qty.
1
Hard Disk Drive (HDD)
1 DC PCB
1 HDD Bracket
1 HDD Harness
1 DC Harness
1 Edge Saddle
3 Harness Clamp (Small)
3 Harness Clamp (Medium)
6 Screw (Short)
2 Screw (Medium)
1 Firmware CD
1 Installation Instructions
8.4.2. Installation
1. Before installing the Hard Disk Drive Unit, make sure the optional Sorting Image Memory is
installed in the memory socket on the SC PC Board first. At least an additional 16 MB
(DA-SM16B) of Sorting Image Memory is required.
Refer to the Installation Instruction of the Sorting Image Memory (DA-SM16B/64B/28B).
2. For UF-9000, V2.xxxxx or higher SC firmware is required. Update the Firmware referring to the
Service Notes "Firmware Update".
3. Install the Hard Disk Drive Unit by following the steps below.
CAUTION!
Turn the Power Switch on the Left Side of the machine to the OFF position, and then
unplug the AC Power Cord before beginning installation. (During a Lightning Storm, to
prevent electrocution disconnect the Telephone Line Cable first before unplugging the
AC Power Cord.)
Ver. 3.0
Description Part No.
See Note
DZEC103051
DZJC000389
DZFP001565 Flat Cable
DZFP001566 Power Supply Cable
DZJK000057 Black-Square
DZJK000004 Black
DZJK000067 White
XTB3+4F
XTW3+6LFC
DZHP010773 For USA version only (UF-9000)
See Note This document
(1) Remove the Rear Paper Tray Cover.
276
UF-9000
DP-180/190
Remarks
APR 2006